Temp Stuff

http://rapidshare.com/files/106977873/Omastar_book.rar.html
http://rapidshare.com/files/106982242/Farfetch_d_book.rar.html
Two new pokemon papercrafts to put on the wiki.

Dragon Instructions

okay, and heres my assembly note, might be a bit long but should help

Model is done in 5 stacking sections:

1 head and neck 2 chest and fore limbs 3 abdomen 4 rear legs and hips
5 tail

Points of Note:

tail-hip connection sucks snail snot and fin notation-registration on spine of the tail is off by one body segment.

Also model is reversed. To make the model appear the same as the photo, fold it inside out so the black lines are inside, though this will make aligning and registration more difficult, also the pole will then most likely have to be mirror imaged or at least the top 2 sections with the white support posts.

Note … abdomen has three square holes in it to slide over the white post squares

  • ed pieces are meant to have a fin on spinal ridge.

Existing sheet lay out
01 chest and upper foreleg
02 03 front legs
04 05 06 abdomen
07 08 rear hip
09 10 rear leg
11 head accessories
12 13 14 tail
15 nose whiskers lower jaw
16 nasal snout eyes top of head horns
17 sharp neck curve and neck
18– 23 base

assembly recommendation
Head pages 15 16 11 neck 17 chest an upper forelegs 1 forelegs 2 - 3 abdomen 4 5 6 rear hips 07 rear legs 08 09 tail 12 13 14

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License